• Single Controller Stand, Headset Stand, and Cat Controller Stand

1. To turn your controller/headset stand on: simply plug in the provided micro-usb power cable to a usb port on your game console/pc or a 5v usb power block.
2. You can alternate between the different colors and light modes on the remote as well as change brightness and transition speeds

• 2 Controller Stand and 4 Controller Stand

1. To turn your controller stand on: simply plug in the provided micro-usb power cable to a usb port on your game console/pc or a 5v usb power block, and hold the power button   for 3 seconds. To turn it off, just long press the power button again.
2. Tap the power button to alternate between rotating and continuous light modes.

• Light-Up Record Shelf and Stand

1. Tap the power button to alternate between colors and light modes. The + and - symbols adjust the brightness, but also adjust the rate of transition between colors on the special light modes. You can hold the power button to turn off the light and hold the color you selected instead of cycling every time.
2. To mount the shelf: Use a couple of nails or screws, in the provided screw holes positioned in the clear acrylic section of the shelf.

• Now Playing Neon Sign

To mount the provided shelf: Use a couple of nails or screws in the provided screw holes positioned in the clear acrylic section of the shelf.

For the Neon Sign, stand-off mounting screws are provided. Please refer to this diagram when installing

1. Hold the sign up where you want it to be and make sure it is level. With it in position, mark both holes for your mounting hardware. (Please note the sign should be leveled based on the letters, and not the position of the mounting holes.)
2. If securing in drywall: use the provided anchors by first drilling out the drywall on the marks with a ⅛” bit, or take the head of a screwdriver and poke the holes manually. If installing in wood: skip the anchor and drill a ⅛” pilot hole instead.
3. With the anchor (pilot hole for wood) in place, put the screw through the barrel and gently tighten with a hand screwdriver until the barrel is flush and secure with the wall.
4. Install the rest of the pieces to the standoffs based on the linked diagram above. Making sure there is a rubber washer between each piece of metal and the sign when tightened. When tightening the cap you need only to hand tighten until secure.

Please note that use of the stand-off wall mounts is optional, you can also use screws or nails for the Neon Sign

• Nintendo Switch Dock Panel and Wall Mount

1. To turn the dock panel on: simply plug in the provided micro-usb power cable to a usb port on your game console/pc or a 5v usb power block.
2. Tap the power button to alternate between colors and light modes. The + and - symbols adjust the brightness, but also adjust the rate of transition between colors on the special light modes. You can hold the power button to turn off the light and hold the color you selected instead of cycling every time.
3. To wall mount the dock panel: Use a couple of nails or screws, in the provided screw holes positioned in the clear acrylic section of the panel.

To turn the light on: simply plug in the provided micro-usb power cable to a 5v usb power block.

You can alternate between the different colors and light modes on the remote as well as change brightness and transition speeds.